- 您现在的位置：买卖IC网 > Sheet目录868 > LSN2-T/16-W3N-C (Murata Power Solutions Inc)CONV DC/DC 52.8W 16A.75-3.3V SIP
LSN2 Series
Non-isolated, DOSA-SIP, 6/10/16A
Selectable-Output DC/DC Converters
R TRIM ( ? ) = _____________ – 1000
through forward biased ESD diodes.Conventional DC/DC’s may fail to start up
correctly if there is output voltage already present. And some external circuits
are adversely affected when the low side MOSFET in a synchronous recti?er
converter sinks current at start up.
The LSN2 series includes a pre-bias startup mode to prevent these initializa-
tion problems. Essentially, the converter acts as a simple buck converter until
the output reaches its set point voltage at which time it converts to a synchro-
nous recti?er design. This feature is variously called “monotonic” because the
voltage does not decay (from low side MOSFET shorting) or produce a negative
transient once the input power is applied and the startup sequence begins.
Don’t Use Pre-Biasing and Sequencing Together
Normally, you would use startup sequencing on multiple DC/DC’s to solve the
Pre-Bias problem. By causing all power sources to ramp up together, no one
source can dominate and force the others to fail to start. For most applica-
tions, do not use startup sequencing in a Pre-Bias application, especially with
an external active power source.
If you have active source pre-biasing, leave the Sequence input open so
that the output will step up quickly and safely. A symptom of this condition is
repeated failed starts. You can further verify this by removing the existing load
and testing it with a separate passive resistive load which does not exceed full
current. If the resistive load starts successfully, you may be trying to drive an
external pre-biased active source.
D12 Models Resistor Trim Equation:
10500
V O – 0.7525
V OUT (Typ.) 0.7525V 1.0V 1.2V 1.5V 1.8V 2.5V 3.3V 5V
R TRIM (kΩ) Open 41.424 22.46 13.05 9.024 5.009 3.122 1.472
Voltage Trim
The LSN2 Series may also be trimmed using an external voltage applied
between the Trim input and Output Common. Be aware that the internal “load”
impedance looking into trim pin is approximately 5k ? . Therefore, you may
have to compensate for this in the source resistance of your external voltage
reference.
Use a low noise DC reference and short leads. Mount the leads close to the
converter.
Two different trim equations are used for the W3 and D12 models.
W3 Models Voltage Trim Equation:
V TRIM (in Volts) = 0.7 – (0.1698 x (V O – 0.7525))
The LSN2 W3 ?xed trim voltages to set the output voltage are:
It may also be possible to use pre-bias and sequencing together if the Pre-
Bias source is in fact only a small external bypass capacitor slowly charged by
leakage currents. Test your application to be sure.
V OUT (Typ.) 0.7525V
V TRIM Open
1.0V 1.2V 1.5V 1.8V 2.5V 3.3V
0.6928V 0.624V 0.5731V 0.5221V 0.4033V 0.267V
Output Adjustments
The LSN2 series includes a special output voltage trimming feature which
is fully compatible with competitive units. The output voltage may be varied
using a single trim resistor from the Trim input to Power Common (pin 4) or an
external DC trim voltage applied between the Trim input and Power Common.
D12 Models Voltage Trim Equation:
V TRIM (in Volts) = 0.7 – (0.0667 x (V O – 0.7525))
The LSN2 D12 ?xed trim voltages to set the output voltage are:
The output voltage range for W3 models is 0.75 to 3.3 Volts. For D12 models,
V OUT (Typ.) 0.7525V
1.0V
1.2V
1.5V
1.8V
2.5V
3.3V
5V
the output range is 0.75 to 5 Volts.
V TRIM
Open
0.6835 0.670 0.650 0.630 0.583 0.530 0.4166
R TRIM ( ? ) = _____________ – 5110
IMPORTANT: OnW3 models only,for outputs greater than 3Volts up to
3.3?Volts maximum, the input supply must be 4.5 Volts minimum. To retain
proper regulation, do not exceed the 3.3V output.
As with other trim adjustments, be sure to use a precision low-tempco
resistor (±100 ppm/°C) mounted close to the converter with short leads. Also
be aware that the output voltage accuracy is ±2% (typical) therefore you may
need to vary this resistance slightly to achieve your desired output setting.
Two different trim equations are used for the W3 and D12 models.
W3 Models Resistor Trim Equation:
21070
V O – 0.7525
The W3 models ?xed trim resistors to set the output voltage are:
LSN2 Power Sequencing
Whereas in the old days, one master switch simultaneously turned on the
power for all parts of a system, many modern systems require multiple supply
voltages for different on-board sections. Typically the CPU or microcontroller
needs 1.8 Volts or lower. Memory (particularly DDR) may use 1.8 to 2.5 Volts.
Interface “glue” and “chipset” logic might use +3.3Vdc power while Input/
Output subsystems may need +5V. Finally, peripherals use 5V and/or 12V.
V OUT (Typ.) 0.7525V 1.0V 1.2V 1.5V 1.8V 2.5V
R TRIM (kΩ) Open 80.021 41.973 23.077 15.004 6.947
3.3V
3.16
Figure 6. Trim Connections
www.murata-ps.com/support
MDC_LSN2.C01 Δ Page 9 of 15
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LSN2-T/30-D12-C
CONV DC/DC 150W 30A 0.8-5V SIP
LSS-T/10-W12-C
CONV DC/DC 60W 10A .6-6V SIP
LTM4600HVIV#PBF
IC DC/DC UMODULE 10A 104-LGA
LTM4600IV#PBF
IC DC/DC UMODULE 10A 104-LGA
LTM4601AHVEV#PBF
IC DC/DC UMODULE 12A 133-LGA
LTM4601AIY#PBF
IC DC/DC UMODULE 12A 133-BGA
LTM4602IV#PBF
IC DC/DC UMODULE 6A 104-LGA
LTM4603HVEV#PBF
IC DC/DC UMODULE 6A 118-LGA
相关代理商/技术参数
LSN2-T/16-W3N-C
制造商:Murata Power Solutions 功能描述:DC/DC Converter
LSN2-T/16-W3NG-C
功能描述:DC/DC转换器 52.8W5V/0.75-3.3V16A RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12-C
功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W NonIso DOSA-SIP
RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12G-C
功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W Power Good Out RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12NB-C
制造商:Murata Power Solutions 功能描述:Module DC-DC 1-OUT 0.8V to 5V 22A 112W 12-Pin SIP
LSN2-T/22-D12N-C
功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W Neg polarity
RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/22-D12NG-C
功能描述:DC/DC转换器 12Vin 0.8-5Vout 22A 112W PowerGood NegPl RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
LSN2-T/30-D12
制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Non-isolated, DOSA-SIP, 6/10/16A Selectable-Output DC/DC Converters